CL-NX Plus How to adjust when label stop position is not right

Miho

25 September 2024 06:43

< Measure >
To adjust the label, stop position, or label cut position, please check the printer menu.

Set the [Pitch] in the [Printing] > [Advanced] > [Adjustments] menu to adjust the print position.

•	The above cut reference position for printing indicates the stop position when the media sensor type is set to Gap.

•	You can also adjust when the operation mode is specified to Tear-off or Dispenser.

An adjustment range of the label stop position or cut position may vary depending on the thermal head density if the unit is the dot (constantly plus or minus 3.75 mm).
For more details, please refer to the following web page.
Adjusting the Media Stop Position:

Also please try to clean the media route when label stop position is unstable.
Please see the following video.
For CL4NX/CL6NX Plus Cleaning method:

[02-00123-EN]