Problem/Question
How to configure printer setting to print transparent label.
Applicable To
SATO CL4NX / CL6NX Series
Resolution/Answer
Setup Instructions (For Transparent Labels with Backing Paper)
Please follow the steps below to configure your printer:
1. Set Print Mode
- Navigate to Print Mode
- Select: Continuously
This allows the printer to run without relying on gap detection.
2. Set Sensor Type
- Navigate to Sensor Type
- Select: None
This disables media sensing, which is required because transparent labels may not be detected properly by sensors.
Important Note
After applying the above settings, please take note:
-
Manual adjustment may be required
Operators may need to manually position labels during operation. Please refer to link below.
[03-80301-EN]