|
|
|
•
|
When opening or closing the dispenser unit, be careful not to pinch your fingers.
|
|
The below topic describes the procedure to dispense the label and rewind the liner in the product.
|
|
|
•
|
The maximum diameter of the liner that can be rewound in the product is φ120 mm (4.72").
|
|
•
|
The routing path of the media is shown in the below picture.
|
|
View the video below for the procedure.
|
|
|
•
|
Open the top cover fully to prevent accidental drop of the cover.
|
|
|
2.
|
Push the head lock lever (2) towards the rear.
|
|
3.
|
Pull the media holder guide (3) and media guide (4) away from the product.
|
Turn the knob (5) counterclockwise to release the media guide.
|
4.
|
Load the media in the media holder (6).
|
Make sure that the media roll is all the way in to inside of the product.
|
5.
|
Push the media holder guide (3) lightly against the media roll.
|
|
6.
|
Pass the media below the media damper (7) and the media sensor guide (8) while pushing the media to inside of the product.
|
Make sure that the end of the media extends out the front of the product.
When using the dispenser unit with the part (A) as shown below
|
a.
|
Press the tab (9) at the front of the product.
|
|
b.
|
Use both hands to hold the metal parts on the ends of the roller to pull the dispenser unit (10) open.
|
When using the dispenser unit without the part (A)
|
a.
|
Press the tab (9) at the front of the product to open the dispenser unit (10).
|
|
8.
|
Remove about 80 cm (31.5") of labels (11) from the liner (12).
|
|
9.
|
Pass the liner (12) through the gap of the dispenser unit to the inside of the product.
|
|
10.
|
Adjust the dispenser roller (13) to the center of the label.
|
|
11.
|
Pass the liner (12) below the liner rewinder (14), and attach it with the clip (15).
|
|
12.
|
Rotate the liner rewinder (14) counterclockwise by hand, to wind the liner.
|
|
14.
|
Close the dispenser unit.
|
|
15.
|
Press the media guide lightly against the end of the media, and then turn the knob to lock the media guide.
|
|
|
|
•
|
When closing the top cover, be careful not to pinch your fingers.
|
|
|
17.
|
Press the button (FEED) in Offline mode to feed the media.
|
|
18.
|
Press the button (ONLINE) to change to Online mode.
|
|
|
|
•
|
You need to load the ribbon when printing using thermal transfer.
|
|
|
|
|
•
|
When not using the product for a long time, keep the dispenser unit open to protect the roller.
|
|
[01-01412-EN]
