Perform the auto-calibration for the selected media sensor.
[Auto-calibration]is not available if you have installed the optional linerless cutter kit (CL4NXonly).
Gap + I-Mark
Adjusts both the Gap sensor and I-mark sensor.
Gap
Adjusts the Gap sensor.
I-Mark
Adjusts the I-mark sensor.
The procedure to auto-calibrate the media sensor is as follows:
1.
Push the head lock lever towards the rear to unlock the print head.
2.
Pass the media below the media sensor guide. If you are using labels, remove the label from the liner. Align it so that the media sensor does not detect the I-mark (black mark).
3.
Press the print head down until the head lock lever is locked. To get the correct adjustment result, adjust after you have locked the print head.
4.
Press the/buttons to select the type of sensor to be adjusted.
5.
Press thebutton orbutton.
6.
When the confirmation screen appears, press thebutton to start the sensor adjustment.
7.
The result of the sensor adjustment is shown. To exit the adjustment, press thebutton.
8.
Set to Offline mode. Press thebutton to confirm that the media is fed correctly.
•
If the media is not fed correctly after doing[Auto-calibration], contact your SATO reseller or technical support.
/
buttons to select the type of sensor to be adjusted.
button or
button.