CL-NX Error Message 1126 (Not Enough Power)

Nobutaka Kobayashi

15 November 2024 04:54 Updated

When there is an error with the product, the error message appears on the screen.

Check the cause and countermeasure, and then take appropriate action.

To clear the error:

Press the

button (RETRY), and then execute the retry/release operation set in [Retry Mode], or press the

button (ABORT).

To cancel an entire print job, open and close the top cover to switch the product to Offline mode, and then press the

button (CANCEL).

Cause and Countermeasure

Reference

UHF only

Cause

The [RSSI Filter] function is enabled, and the RSSI value of the inlay is lower than the values set in [Threshold Value].

Countermeasure

◦	Check the tags. Or, check the [Threshold Value] settings.

◦	Adjust [Write Power]/[Read Power].

[01-01448-EN]