Skip to main content
Deutsch Español Français Bahasa Indonesia Italiano Nederlands Polski Português do Brasil ไทย Türkçe Tiếng Việt 简体中文

CL-NX Configuring the Product to Encode Inlays

Miho
Updated
This topic explains the procedures on how to configure the product to encode your inlays.
1.
Examine the media to determine the product settings.
Refer to theCL4NXInlay Configuration Guide for the measurements you should take and what they mean, as well as a list of inlays and their required configurations.
To see theCL4NXInlay Configuration Guide, access the following URL:
https://www.sato-global.com/rfid/guide.html
To use inlays that are not in the Inlay Configuration Guide, contact your SATO sales representative or reseller.
2.
Press thepower button of the operator panel until the LED lights up in blue to power on the product.
3.
When the product is in Online mode, press thebutton on the operator panel to change to Offline mode.
4.
Press thebutton to show the[Settings]menu.
5.
Press the/buttons to select[Interface]and then press thebutton.
6.
Press the/buttons to select[RFID]and then press thebutton.
The[RFID]screen appears.
7.
Press the/buttons to select the item you want to set and then press thebutton.
The adjusting screen appears.
8.
Open the top cover (1).
•
Open the top cover fully to prevent accidental drop of the cover.
9.
Push the head lock lever (2) towards the rear to unlock the print head.
•
The print head and its surroundings are hot after printing. Be careful not to get burned.
•
Touching the edge of the print head with your bare hand could cause injury.
10.
Adjust the position of the RFID antenna. Rotate the dial (3) to align the pointer ▼ (4) with the media being used.
When[Antenna Position]is set to[Standard]in the[Interface]>[RFID]menu, adjust the physical position of the antenna according to the settings required for the specific media and inlay used.
Refer to the "Antenna Position" of the Inlay Placement & Configuration Table in theCL4NXInlay Configuration Guide.
To see theCL4NXInlay Configuration Guide, access the following URL:
https://www.sato-global.com/rfid/guide.html
11.
Load the media and ribbon.
12.
Confirm the operation by printing/encoding a media.
Make sure that you read the data and check that it is correctly encoded.
[02-01486-EN]