CL-NX [Configure QR] – SATO Help Center

Print the product's settings information as a QR code.

1.	Check and set the items as listed on the[Configure QR]menu.

2.	Press thebutton to start the test print. Press thebutton again to pause the print.

To stop the test print, first pause the print and then press the

button.

The setting items are as follows:

Label Width

Shows the necessary media width of the test print.

The necessary media width is 50.8 mm (2") for[Small].

Label Length

Set the length of one piece of the media used for the test print.

The setting range varies depending on the print resolution of the product.

The setting range is as follows:

Pitch

Set the print position in the vertical direction.

The setting range varies depending on the print resolution of the product.

The setting range is as follows:

When you decrease the setting value, the print position moves in the feed direction (toward the front part of the media).

When you increase the setting value, the print position moves opposite the feed direction (toward the end part of the media).

Offset

Set the stop position of the media.

The setting range varies depending on the print resolution of the product.

The setting range is as follows:

When you decrease the setting value, the stop position moves in the feed direction (toward the front part of the media).

When you increase the setting value, the stop position moves opposite the feed direction (toward the end part of the media).

Darkness Adjust

Fine tune the print darkness of the test print.

The setting range is from 0 to 99.

0 is the lightest and 99 is the darkest.

•	The value of[Label Length],[Pitch],[Offset]and[Darkness Adjust]set in the[Configure QR]menu will be reflected to the same item settings in the[Factory]menu,[Configure List]menu,[Paper Sensor]menu and[Head Check]menu.

[02-01520-EN]