Skip to main content
Deutsch Español Français Bahasa Indonesia Italiano Nederlands Polski Português do Brasil ไทย Türkçe Tiếng Việt 简体中文

CL-NX [Paper Sensor]

Miho
Updated
Print the detection result of the media sensor level.
1.
Check and set the items as listed on the[Paper Sensor]menu.
2.
Press thebutton to start the test print. Press thebutton again to pause the print.
To stop the test print, first pause the print and then press thebutton.
The setting items are as follows:
Label Width
Shows the necessary media width of the test print.
The necessary media width is50.8 mm (2")for[Small].
Label Length
Set the length of one piece of the media used for the test print.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
CL4NX
CL6NX
203 dpi
(1 dot = 0.125 mm (0.0049"))
400 to 1600 dots
400 to 1600 dots
305 dpi
(1 dot = 0.083 mm (0.0033"))
600 to 2400 dots
600 to 2400 dots
609 dpi
(1 dot = 0.042 mm (0.0017"))
1200 to 4800 dots
-
Pitch
Set the print position in the vertical direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
CL4NX
CL6NX
203 dpi
(1 dot = 0.125 mm (0.0049"))
-30 to 0 to 30 dots
-30 to 0 to 30 dots
305 dpi
(1 dot = 0.083 mm (0.0033"))
-45 to 0 to 45 dots
-45 to 0 to 45 dots
609 dpi
(1 dot = 0.042 mm (0.0017"))
-90 to 0 to 90 dots
-
When you decrease the setting value, the print position moves in the feed direction (toward the front part of the media).
When you increase the setting value, the print position moves opposite the feed direction (toward the end part of the media).
Offset
Set the stop position of the media.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution
CL4NX
CL6NX
203 dpi
(1 dot = 0.125 mm (0.0049"))
-30 to 0 to 30 dots
-30 to 0 to 30 dots
305 dpi
(1 dot = 0.083 mm (0.0033"))
-45 to 0 to 45 dots
-45 to 0 to 45 dots
609 dpi
(1 dot = 0.042 mm (0.0017"))
-90 to 0 to 90 dots
-
When you decrease the setting value, the stop position moves in the feed direction (toward the front part of the media).
When you increase the setting value, the stop position moves opposite the feed direction (toward the end part of the media).
Darkness Adjust
Fine tune the print darkness of the test print.
The setting range is from 0 to 99.
0 is the lightest and 99 is the darkest.
•
The value of[Label Length],[Pitch],[Offset]and[Darkness Adjust]set in the[Paper Sensor]menu will be reflected to the same item settings in the[Factory]menu,[Configure List]menu,[Configure QR]menu and[Head Check]menu.
[02-01521-EN]