Skip to main content
Deutsch Español Français Bahasa Indonesia Italiano Nederlands Polski Português do Brasil ไทย Türkçe Tiếng Việt 简体中文

CL-NX RFID Error and Reset Timing

Miho
Updated
Applicable models: CL4/6NX
Error Signal Output with One-shot Pulse
Turns on the signal when a read/write error occurs. The signal will be turned off after 100 to 500 ms.
(1) Active low
(2) Active high
When the reprint count reaches the specified number, the RFID tag error and RFID error are outputted at a time. The RFID error output is always a long pulse.
Timing Chart of Error Signal Output with One-shot Pulse
Item
RFID Reprint Twice - One-shot Pulse Output Waveform
Error
Reprint 1st
Reprint 2nd
Error Signal Output with Long Pulse
Turns on the signal when a read/write error occurs. The signal will be turned off if the error is cleared.
(1) Active low
(2) Active high
When the reprint count reaches the specified number, the RFID tag error and RFID error are outputted at a time. The RFID error output is always a long pulse.
Timing Chart of Error Signal Output with Long Pulse
Item
RFID Reprint Twice - Level Output Waveform
Error
Reprint 1st
Reprint 2nd
*1 Continues until after the error printing operation is completed.
[02-01488-EN]