CL-NX About the Base Reference Point

Miho

16 May 2026 09:53 Updated

Applicable models: CL4/6NX

The base reference point is the point at which one determines the print position and stop/cut/dispensing position.

The base reference point differs depending on the operation mode or media sensor you use.

Continuous Mode/Tear-off Mode

I-mark Label	Gap Label
(1) Feed direction (2) Print and stop position	(1) Feed direction (2) Print and stop position

Cutter Mode

I-mark Label	Gap Label
(1) Feed direction (2) Print and cut position	(1) Feed direction (2) Cut position (3) Print position

Dispenser Mode

I-mark Label	Gap Label
(1) Feed direction (2) Print and dispensing position	(1) Feed direction (2) Dispensing position (3) Print position

Linerless Mode (CL4NX only)

I-mark Linerless Label

(1) Feed direction

(2) Cut position

(3) Print position

(4) Non-printable zone (5 mm / 0.2")

[02-02230-EN]