CL-NX Dispenser Mode, Backfeed After Printing, with Pulse Input, and with the Dispenser Completion Signal (Head Check Enabled)

Miho

16 May 2026 09:54 Updated

Applicable models: CL4NX/6NX

Operation

*1 The dispenser sensor confirms the dispensing condition and the product does not perform the next operation until the label is dispensed.

Timing Chart

*1 Keep the PRIN (print start) signal to "Low" until the PREND (print end) signal is outputted.

*2 After backfeed, the PREND signal is outputted.

[02-01699-EN]