Applicable models: CL4/6NX
Set the media feed amount for
Tear-off, cut and dispense stop. Set the media feed amount based on the print head position of 0.
The actual media feed amount is the value of
[Offset] +
[Finisher Feed].
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
|
|
|
•
|
When [Printing Mode] is set to [Use Ribbon], the length of label backfeed needs to be under 30 mm (1.18"). If it is over 30 mm (1.18"), the end of the ribbon may be falsely detected.
|
|
•
|
A message prompting you to restart the product will appear on the Online/Offline screen if you have made any changes. In such a case, reboot the product to apply the settings.
|
|
[02-03274-EN]
