The Wi-Fi Direct function is enabled if you have selected[Infrastructure]in the[Mode]menu. If you have changed the setting from[Ad-hoc]to[Infrastructure]in the[Mode]menu, reboot the product before setting the Wi-Fi Direct function.
The setting procedure is as follows:
1.
Set the device name for the product using[Device Name]. You can enter 1 to 32 characters. Alphabets (capital and small letters), numbers and symbols can be used.
Press thebutton to return to the[Wi-Fi]menu and press thebutton to enable changes.
2.
Select[Connect]to search and show the connectable device names or to accept connection requests when the product is the GO (Group Owner).
Select the device name you want to connect using the/buttons, and press thebutton.
3.
Select[Start Group]if you want to start a new persistent group or select a group from the list.
4.
Select[Remove Group]to remove the persistent group in step 3.
5.
Complete the connection according to the display on the product or device you want to connect.
6.
Select[Disconnect]if you want to stop the connection.
•
You can connect a maximum of 10 devices.
•
When Wi-Fi Direct is active,[Device Name]cannot be changed.
•
[Start Group]and[Remove Group]are shown only if Wi-Fi is active and the product is not connected to a Wi-Fi Direct network.
•
[Remove Group]is shown if Wi-Fi is active and the product is connected.
•
After setting up a start group, the product will be set to the GO (Group Owner) and will wait for a connection request from another device.
•
If the product is powered off during a persistent group connection, the group will be started automatically after the product is powered on.