Skip to main content
Deutsch Español Français Bahasa Indonesia Italiano Nederlands Polski Português do Brasil ไทย Türkçe Tiếng Việt 简体中文

CL-NX Wireless LAN Interface Settings

Miho
Updated

Applicable models: CL4NX/6NX
Please refer to the below.

Configure the wireless LAN interface settings such as the IP address by using the All-In-One Tool.
Before setting the wireless LAN interfaces, connect the product to a computer with a USB cable or LAN cable other than the wireless LAN interfaces.
The following explanation uses an example in which the product and computer are connected with a USB cable.
mceclip0.png •The factory settings of the wireless LAN interfaces are as follows:
Wireless Mode
Ad-hoc
Communication Channel
6
SSID
SATO_PRINTER
Security
None
IP Address
0.0.0.0
Subnet Mask
255.255.255.0
Gateway Address
0.0.0.0
• When you use the wireless LAN connection, the communication condition settings must be configured according to your network environment. For details, consult with the network administrator.
• If the product's[Settings]>[Interface]>[Network]>[Advanced]>[Firewall]>[Enable]menu is set to[Enabled],[Settings]>[Interface]>[Network]>[Advanced]>[Firewall]>[Allow Services And Ports]>[SATO All-In-One Tool]must be set to[Enabled].
1.
Connect the USB cable to the product, and power on the product.
mceclip0.png

• If the product is turned on without installing the printer driver, Windows' Plug & Play runs.

◦ For Windows 7 or later, the product will be added to[Devices and Printers]as an unspecified device.

◦ If a message is displayed that indicates new hardware is detected on Windows Server 2008, cancel it.
2.
Activate[SATO]>[SATO All-In-One Application]on the computer.
3.
Select[Auto-Discover]from the[Tools]menu on the main screen.
The product is shown on the main screen.
If it is not detected, try to add it manually from[Add new printer].
Adding the Product Manually from[Add new printer]
a.
Select[Add new printer]from the[Printer]menu on the main screen.
b.
Select[USB Port]. Select the product to add from the drop down list, and click[OK].
The product is added on the main screen.
4.
Select the product on the main screen, and click[Interface Configuration].
5.
Open the[Wireless LAN Security]tab.
6.
Select or enter the wireless LAN settings as necessary.
7.
When the settings are completed, click[Set].
The settings on the screen are sent to the product.
8.
Power off the product, disconnect the USB cable, and power on the product.
[03-01620-EN]