The icons on the screen indicate the current state of the product.
Only a limited number of icons can be displayed on the screen. Therefore, important icons have priority over the other icons.
Current state of the product
|
|
|
|
|
The product is in stopped state. (Offline)
|
|
|
The product is receiving data.
|
|
|
The product is printing. (Online)
|
|
|
The product has stopped printing. (Offline)
|
|
|
The product is waiting for dispenser.
This icon only appears if you have selected the [Dispense Mode] (PW208NX only) or the [Linerless] operation mode.
|
|
|
HEX dump mode is enabled.
This icon only appears if you have selected [Enabled] in the HEX dump mode.
|
Interface Information
|
|
|
|
|
|
|
This icon appears when the USB port is in use.
|
|
|
|
Bluetooth is available but not connected.
|
|
|
|
Bluetooth is available and connected.
|
|
|
|
Wi-Fi is available but not connected.
This menu only appears if the product supports wireless LAN.
|
|
|
|
This menu only appears if the product supports wireless LAN.
|
|
|
|
This menu only appears if the product supports wireless LAN.
|
|
|
|
This menu only appears if the product supports wireless LAN.
|
|
|
|
This menu only appears if the product supports wireless LAN.
|
|
|
|
This icon appears when Wi-Fi Direct is enabled.
This menu only appears if the product supports wireless LAN.
|
|
|
|
This icon appears when a USB memory is connected.
|
|
|
|
|
|
|
|
|
|
|
|
|
-: Enlarged icon is not displayed.
|
|
|
|
|
Status Icons
|
|
|
|
|
|
|
|
|
The remaining battery level is displayed.
When the Eco Charge function is set to [Disabled], different information is displayed depending on the battery level.
The remaining battery level is also displayed in a numeric value (%) on the left side of the icon.
|
|
|
|
|
|
The battery is being charged using the AC adapter.
When the Eco Charge function is set to [Disabled], different information is displayed depending on the battery level.
The remaining battery level is also displayed in a numeric value (%) on the left side of the icon.
|
|
|
|
|
|
The battery cannot be charged due to the internal temperature of the product being too high or too low.
|
|
|
|
|
|
Please replace the battery if  or  is displayed.
|
|
|
|
|
|
A receive buffer near full warning was detected.
The receive buffer is almost full. Please wait until the icon disappears.
|
|
|
A command error was detected.
The print data may be incorrect. Please check the print data.
|
|
|
There is a broken element in the print head.
A head error may be displayed depending on the print layout.
|
|
|
IP address could not be acquired.
Reconfigure your network connection and settings, and restart the product once the network settings are displayed correctly.
|
|
|
Authentication with iOS has been aborted. Wait until the icon disappears (approx. 130 sec.) and then re-authenticate with iOS. Do not power off the product or remove the battery while the authentication with iOS is in progress.
|
|
|
Bluetooth connection with iOS cannot be established due to failure of the authentication chip. Please contact the SATO technical support.
|
|
|
The product information could not be sent to the SOS.
|
|
|
|
|
|
The product is due for cleaning.
|
|
|
The print head or platen roller is due for replacement.
|
[02-00878-EN]
