To enable or disable HEX Dump Mode on the WS4 printer, you can do so directly from the printer by following the steps below.
Enable HEX Dump Mode
1. Perform a self-test print.
2. Once the self-test print is completed, the printer will automatically enter HEX Dump Mode.
For instructions on performing a self-test print, refer to:
WS4 - Factory Test Print Mode – SATO Help Center
Disable HEX Dump Mode
1. Turn the printer OFF.
2. Turn the printer ON again.
The printer will exit HEX Dump Mode
12-80318-EN